Furnace and Air Conditioner
- clean burners
- clean flame sensor
- check & adjust pilot operation
- lubricate all moving parts
- monitor flue draft for safe operation
- check & tighten all loose electrical connections
|
- check & test safety controls
- monitor voltage & amperage draw on all motors
- adjust air flow for proper temp rise
- check thermostat
- check for cracked heat exchanger
- inspect cooling coil (if accessible)
|
- check primary & secondary drains
- adjust & clean blower compartments
- clean & check condenser coil
- check operating pressures
- monitor air conditioning cycle
- recommend improvements if needed
|
Geothermal System
- check filter for cleanliness
- check flow rate
- check temperature of water entering and leaving unit
- check coil for cleanliness
- check loop pressures on heating & cooling
- check all stages of operation with thermostat
- take electrical amp draws to ensure correct parameters for efficiency
- inspect drain pan and trap
- check overall condition of system
We service most makes and models.
Call us today to arrange an appointment.
